What Does a Chain Link Fence Cost in Rupert, Idaho?

Chain link prices in Rupert

Installed — material and labor together.

Configuration	Installed cost per linear foot	150-foot run
4 ft, 11-gauge galvanized	$10 – $16	$1,500 – $2,400
5 ft, 11-gauge galvanized	$12 – $19	$1,800 – $2,850
6 ft, 11-gauge galvanized	$14 – $22	$2,100 – $3,300
6 ft, 9-gauge galvanized	$18 – $25	$2,700 – $3,750
Vinyl-coated, add	+$3 – $8	+$450 – $1,200
Commercial perimeter, 8 ft, 9/6-gauge	$30 – $60	quoted per project

Gates price separately: $350–$900 for a walk gate, $900–$2,500 for a drive gate. A cantilever slide gate for commercial duty prices above that. Removing an existing fence adds $3–$10 per foot.

Gauge is the number to ask about

Chain link is sold on height and forgotten on gauge, and gauge is what decides whether the fence is still tight in ten years. Lower numbers mean thicker wire.

• 11-gauge is the residential standard. Fine for a back yard, a dog run, or a garden enclosure.
• 9-gauge is noticeably heavier and belongs anywhere something will lean on it — livestock, equipment, a plant perimeter, or a dog with a project. The upcharge is a few dollars a foot against the cost of re-stretching a fence that stretched.
• 6-gauge is industrial, and in this area it shows up on food-plant perimeters rather than on properties.

Also ask about the coating method. Galvanized-after-weave coats the wire after the fabric is made, so the cut ends at the selvage are coated too. Galvanized-before-weave leaves those ends bare, and bare ends are exactly where rust starts on a fence line that sits wet through irrigation season.

The commercial number is a different conversation

Minidoka and Cassia counties sit inside the densest food-manufacturing region in the United States. Plant perimeter work here is not scaled-up residential fence — it is heavier Schedule 40 or SS-grade pipe, 9-gauge or 6-gauge fabric, knuckled or barbed selvage depending on the security requirement, and cantilever slide gates rated for hundreds of cycles a day rather than a few.

That puts it in the $18–$60 per linear foot range depending on height, gauge, and whether access control is in scope, and it is always quoted after a site walk rather than off a plan. Phasing matters as much as price: perimeter work gets sequenced so no run is open overnight and gate cutovers land between shifts. See commercial fencing.

What moves a chain link quote

• Terminal posts. Every corner, end, and gate post needs bracing that can carry full fabric tension. A run with six corners costs more than a straight run of the same length.
• The hardpan. Post holes that stop on the duripan at 26 inches leave posts with no lateral resistance, and chain link telegraphs that fast — the fabric pulls the terminals in toward the run. See digging through the hardpan.
• Top rail vs. top wire. A top rail is stiffer and looks better; a tension wire is cheaper and is standard on agricultural runs.
• Slats or windscreen, which change the wind load and therefore the post specification.

Bottom line

Budget $10–$25 per linear foot installed for residential chain link in Rupert. Pay the small upcharge for 9-gauge if anything is going to lean on it, and pay for vinyl coating if your line runs near a lateral. For commercial and plant perimeter work, expect $18–$60 per foot after a site walk.

Call (208) 732-2816 for a free measure.